This video walks you through the following steps in the installation process:

  1. Locate the vehicle’s diagnostic port, and ensure proper voltage.
  2. Install the external antenna, and route the cables.
  3. Free up existing JPort, and install the HD Pass-Thru Cable.
  4. Mount the replacement diagnostic port.
  5. Connect the white wire to ignition, and tape off unused power harness wires.
  6. Since the publication of this video, the installation process for this device has changed. Please review the HD White Wire insert before you install your device.


  7. Connect the antenna cables to the device.
  8. Connect the HD Pass-Thru Cable to the device.
  9. Verify installation, and tamper-proof remaining connections.
  10. Mount the device.
This entry was posted in   .
Bookmark the   permalink.